Concrete Stamping: Learn How To Do it Yourself

Have you resolved to undertake concrete stamping to give an enhanced look to your house? Well, you can do it easily yourself without having to spend any extra dollars, by just following a few simple steps.

Firstly, it is required to select the print color, as this plays the prominent trick in the entire procedure. Of course, there are wide ranges of colors, where the greatest way to select your color is to test one or two similar colors to determine whether it really suits you, as there will be plenty of variables. While picking out a certain color you also need to bear in mind the surrounding atmosphere of the concrete, such as sunlight and other colors being your household paint or even the grass color. You just need to pick the correct contrast.

With initially getting started with a new stamping concrete project, it is recommended to implement with a maximum of 100 square feet. Firstly allow your concrete truck driver for putting the selected color inside the truck, and letting it blend for minimum of 10 min. you may observe some changes to the color as it releases, but don’t get anxious as then you will consider some variation to obtain the selected color pattern for the project.

Next what you need to do is place the concrete into the print, following the use of a screed board. Basically, screed board is put into play for leveling the concrete, and also to dig down the stones inside the cement.

Further, inside your print work put the wet concrete, and let it go leaving about half inch greater height than the print. You can possibly use a tool known as concrete rake to get approximates of the height. Once you are done with settling the concrete, then the screeding procedure comes in. To put this into action, you will require a second helping hand, which will assist you the concrete over the print to level accurately. Next, you will require a bull float for sealing the exterior of the concrete.

Basically you have to run the bull float from front to back over the concrete, repeating the procedure with respect to every side. Don’t get concerned, about the concrete getting over-trimmed, because the stamp will absolutely remove the flat appearance.
Now, it’s the right time to stamp the concrete. First, use a garden sprayer to spray over the area you want to place the stamp. This liquid will allow the rubber stamp to place smoothly without harming the concrete finishing. Just focus on spraying the targeted area, then put down each stamp. Repeat the procedure until you are done.

Following, keep the project idle for the coming 4-5 days, and then it’s the time for putting in other colors or the antique juncture. For this very task, you will require an antique agent, where you are suggested to use charcoal or grey if it’s your first project. The entire remedy is to blend together- 5 table spoons of antique agent and xylene, with one gallon gardening sprayer. Stir it for about 50 seconds before finally spraying it to the concrete.